Water based parts washers / aqueous part washer / parts cleaners from Kleen-Tec
- AT A FRACTION OF THE COST!
Effective heating in heated solution. Safe, energy-efficient thermostatically controlled heaters preset to 110 degrees F boosts cleaning power.
Large oversized sink for high productivity cleaning large parts.
Trouble free oil removal. Integrated weir continuously skims floating oil from basin. Waste oil is drained through a dump valve.
Solution stays clean. Drain design keeps surface oils from contaminating clean solution. Pump mounted filter removes particulates.
Simplified cleanout. Hinged sink tips to side so unit can remain flush with wall during clean-out. Pump slides out for easy access.
Operator safety. Liquid tight NEMA controls, GFI protection, plus the advantage of cleaning without solvents
Plastic and Stainless steel durability. No worries about corrosion.
No VOC emissions, and no EPA permit requirements.
Economical heated drum mounted parts washer designed for use with aqueous based cleaning solutions.
Corrosion resistant heavy-duty pump.
Flexible spigot.
Flo-Thru brush with adjustable fluid control.
Designed for easy servicing, heater, pump and thermostat module can be removed in minutes from sink basin.
Heavy-duty vacuum formed sink.
Liquid level sight tube.
Operating capacity 20-25 gallons.
Automatic thermostat preset to 110 degrees.
Ground fault circuit interrupter for added safety.
115 Volts, 15 Amps
Individual switches for heater and pump.
Stainless steel lid.
Stainless steel lid closure.
Optional soak tray.
Uses KT600C or KT685-5 water-based degreaser.
Designed to help protect the environment!
Drum is included
Our Price - $882
FREE SHIPPING*
Our Price - $97
FREE SHIPPING*
7577 Soak Tray
Our Price - $28
FREE SHIPPING*
Designed for use with Aqueous Cleaning Solutions
Ground fault circuit interrupter for added shock resistant safety.
Heater thermostatically controlled to 110 degrees.
Thermostatic capillary protected by stainless steel thermowell, chemical resistant.
Dual switches - heater and pump.
Heated unit 115 volt, 15 amps.
Also available in 220 volt.
Designed for easy servicing, heater - pump and thermostat module can be removed in minutes from sink basin.
Stainless steel drain filter system.
Optional drum P/N 2565.
Our Price - $955
FREE SHIPPING*
Optional drum not included
Our Price - $89
FREE SHIPPING*
Our Price - $97
FREE SHIPPING*
7062 Cartridge
Our Price - $17
FREE SHIPPING*
Our Price - $72
FREE SHIPPING*
Flexible Spigot, Flo-Thru Brush, Soaking Parts, Designed to Accomodate Water-Based Degreaser Heated to 110 Degrees
Dual filtration system. Prefilter and drain filter
Corrosion resistant heavy-duty pump
GFCI for added shock resistant safety
Spigot with fluid control valve
Heater thermostatically controlled oreset to 110 degrees
Flow-thru brush with adjustable fluid control valve
Thermowell for protection of the thermostat capillary bulb
Low level fluid sensor
Stainless steel lid and lid closure
10 Gallon soaking capacity
Quick sink removable fore easy servicing
Filter system prolongs life of solution
Working Area: 34"L x 23"W x 9"D
Overall Size: 34"L x 23"W x 33"H
Capacity: 45 Gallons
Weight - 80lbs.
Our Price - $1032
FREE SHIPPING*
The right combination - Engineering / Quality / Technology
This is two washers in one - A parts washer and a mobile brake washer. It utilizes aqueous cleaning based technology. Thermostatically controlled heater. Durable high density plastic construction. Large cleaning compartment.
Four colors available - Orange, Green, Black, Blue
- Dual filtration system - Prefilter and drain filter
- Corrosion resistant heavy duty pump
- Heavy duty rolling cart
- GFCI protected for safety
- Spigot with fluid control valve
- Heater thermostatically controlled - preset to 110 degrees F
- Flow-thru brush with adjustable fluid control
- Thermo-well for protection of the thermostat capillary bulb
- low level fluid sensor
- 10 gallon soaking capacity
- 45 gallon capacity
- Quick sink removable for easy servicing
- Filter system prolongs fluid life
- Optional Stainless steel lid
- Cart includes two heavy duty locking casters and two 10" wheels with 3/4" axles
Mfg. Sugg. Retail Price - $1661
Our Price - $1225
FREE SHIPPING*
Sink Length - 34"
Width - 23"
Depth - 9"
Overall Size -
34"L x 23"W x 33"H
Flexible Spigot, Flo-Thru Brush, Soaking Parts, Designed to Accomodate Water-Based Degreaser Heated to 110 Degrees
Corrosion resistant heavy-duty pump.
Heavy-duty roto-cast thermoplastic cleaning basin - large cleaning capacity.
Two removeable stainless steel shelves
Parts washer completely supported by heavy-duty stand
Ground fault circuit interrupter for added shock resistant safety
Filter system - prolongs fluid life Filter cartridge P/N 7062
Soaking capacity up to 30 gallons
Spigot with fluid control valve
Designed for non-flammable water-based cleaning solutions
Heater thermostatically controlled-preset to 110 degrees
Spring loaded stainless steel lid closure with 'fire link'
Low level fluid sensor
Mechanical agitation - 15 spray heads with fluid control valve
Dual switches - heater and pump
Flow-thru brush with adjustable fluid control
CSA and NRTL/C approved
Shown with optional light.
Model KT4000-5 comes standard with oil skimmer
No Skimmer
Mfg. Sugg. Retail Price - $1591
Our Price - $1315
FREE SHIPPING*
Overall Dimensions: 26"W x 45"L x 37.5"H
Weight: 155 lbs.
With optional Skimmer
Mfg. Sugg. Retail Price - $1882
Our Price - $1625
FREE SHIPPING*
This is the ultimate water based parts washer.
Cartridge P/N 7062
Our Price - $15
FREE SHIPPING*
Mechanical Agitation and
Pump Pre-Filter
Built in control panel for safety and convenience.
Easy access to machine base. Hinged sink tips to the side for easy access to machine base.
Corrosion resistant high density polyethylene double wall construction will not crack, dent, or peel.
Solution stays clean. Oil skimming features and sink drain design keep surface oils from contaminating clean solution.
Trouble-free oil removal. Integrated weir continuously skims floating oil from the sink. Accumulated oil is removed through the weir drain valve from machine base.
No particulate problems. Externally mounted unique bag type cartridge filter captures abrasive materials when cleaning critical parts and helps keep solution clean for a longer life.
Operator safety. Includes GFI protection, high temperature cutout, and an air actuated switch, operated by hand or knee, that controls recirculating pump & separates operator from electrical contact.
Low liquid level Shut off / Indicator Light. Indicates when solution should be added to machine. Automatically shuts off heater and pump when fluid level gets too low for safe operation.
Hinged Sink
Sink Capacity: 20 Gallons/300 lbs.
Work Area: 34"L x 19-1/2"W x 10"D
Machine Overall: 39"L x 30"W x 37-1/2"H
Pump Output: 4.5 GPM @ 3" Head
Electrical Requirement: 120V 15Amp 1-Ph
Shipping Weight: 90 lbs.
Our Price - $1499
FREE SHIPPING*
Extra Heavy
Heavy
Medium
Light
3
5
8
12
to
to
to
to
1
1
1
1
Use with all Kleen Tec Aqueous Parts Washers
Mixes with water - see chart to right ---->
Biodegradeable, Non-toxic
Non-Flammable, Non-Abrasive, Non-corrosive
Extends Cleaning Life
VOC Compliant
Includes Rust Inhibitors
Lifts grease, grime, surface oxides and carbon buildup
Forms lightly held emulsion
FREE SHIPPING*
5 Gallon Pail - Price - $164
FREE SHIPPING*
55 Gallon Drum - Price - $1008
FREE SHIPPING*
You can go the solvent-based parts washer route. But when you consider the cost of solvent VS the cost of our water-based solution, you actually save money in the long run.
And with the quality of these parts cleaners, there will be a long run!
Customer responsible for unloading from delivery truck on truck freight shipments..
CT residents, add state sales tax.
Please see our TERMS page for terms and conditions.
Automotive Service Equipment .com
Don't wait - we can't call you - Contact us now!
and increase your shop's profits -
CONTACT US NOW!
Automotive Service Equipment .com
Get the best - for less!
CLICK HERE TO PLACE ORDER, TO REQUEST A CATALOG OR MORE INFORMATION
Phone: 800-229-6218 or 860-626-9633
Fax: 419-831-0245
CLICK HERE TO EMAIL: contact@asedeals.com
CLICK HERE TO RECEIVE MONTHLY EMAILS OF OUR SPECIAL DEALS!
or just give us your feedback
Our monthly special deals are available exclusively to subscribers! Don't miss out - sign up now!
Your email address will be kept confidential and you won't recieve mass emailings from us.
ORDER STATUS / ORDER FORM / FINANCING / SITE SEARCH / REQUEST CATALOG
AUTOMOTIVE LIFTS / TRUCK LIFTS / AIR COMPRESSORS / JACKS
BATTERY CHARGERS / JUMP STARTERS / PARTS WASHERS / WELDERS / PLASMA CUTTERS
WHEEL SERVICE / TOOL BOXES / TUBE BENDERS / SHOP EQUIPMENT
